Heating Systems Performance Comparisons

Heating Comparisons Graph

Download (PDF, Unknown)

 

Comparing Infrared Heating Panels with Forced Air Furnaces

How Do Prestyl Infrared Heating Panels Compare With Other Infrared Heating Panels

Carbon-based technologies, as used by many infrared panel manufacturers, are prone to causing fires; carbon is an NTC material (Negative Temperature Coefficient). When a portion of the carbon is covered (planter, furniture, etc.) the covered area starts to heat up; when a NTC material heats up the resistance goes down and more heat is generated.  As more heat is generated the cycle continues until a fire results.

  • Prestyl is made from a hybrid aluminum alloy, which is PTC-based (Positive Temperature Coefficient); when it heats up, the resistance goes up and the power is reduced.  The hybrid PTC material is self-regulating.

  • When it is cold (and the system is started up at low temperatures), carbon film will not heat up; the resistance is very high and the energy applied may not be enough to overcome the heat-losses at this cold temperature

  • Prestyl was designed to deice aircraft wings; it will start up at -70 degrees C

  • Unless a sophisticated control system is implemented, PTC (or Prestyl) type heating saves energy over NTC (carbon-based) systems since carbon cannot regulate itself, thus burning unnecessary energy.

  • Heating in the floor (regardless of source) can yield no more than a 50% of “ usable heat” (50% is in the form of radiation and conduction within the floor’s top surface, the other 50% convection and undesired conduction)

  • Prestyl’s heating panels on the ceiling convert 80% of the electrical energy to usable heat (80% is effective heat radiation, 20% convection and undesired conduction)

  • Panels on the walls 60% (60% is usable radiation, 40% convection and undesired conduction)

  • The transfer from energy-input to radiating-surface in the Prestyl panels is very high (98%); other technologies can be as low as 70%, reducing the energy efficiencies listed above (i.e., 0.68 x 50%, 0.68 x 80% and 0.68 x 60%, respectively)

  • Prestyl’s life expectancy is 30-50 years; carbon will last 2-10 years depending on operating temperature

  • Prestyl’s warranty is 25 years.